|
|
содержание .. 1074 1075 1076 1077 ..
ENGINE ASSEMBLY EM-201 < UNIT REMOVAL AND INSTALLATION > [QR25DE] C D E F G H I J K L M A EM N P O • Always be careful to work safely, avoid forceful or uninstructed operations. able reasons, support at the rear axle jacking point with a transmission jack or similar tool before • For supporting points for lifting and jacking point at rear axle, refer to NOTE: REMOVAL Outline Remove the engine and the transaxle assembly from the vehicle downward. Separate the engine and the tran- Preparation 1. Release fuel pressure. Refer to 2. Drain engine coolant from radiator. Refer to CAUTION: • Perform this step when the engine is cold. 3. Remove the following parts. PG-142, "EXCEPT FOR R9M : Removal and Installation" . • Air duct and air cleaner assembly: Refer to . • Engine under cover: Refer to EXT-39, "ENGINE UNDER COVER : Exploded View" . • Radiator hose (upper and lower): Refer to . • Front road wheels and tires: Refer to • Front fender protector (RH and LH): Refer to EXT-35, "FENDER PROTECTOR : Exploded View" . • Exhaust front tube 1 and 2: Refer to 4. Discharge refrigerant from A/C circuit. Refer to Engine Room LH 1. Disconnect all connections of engine harness around the engine mounting insulator (LH), and then tem- CAUTION: Protect connectors using a resin bag against foreign materials during the operation. 2. Disconnect fuel feed hose at engine side. Refer to EM-184, "Removal and Installation" . 3. Disconnect heater hoses. 4. Disconnect control cable from transaxle. Refer to TM-409, "QR25DE : Exploded View" . 5. Remove ground cable at transaxle side. 6. Disconnect CVT fluid cooler hose. Refer to TM-441, "QR25DE : Exploded View" . Engine Room RH 1. Disconnect vacuum hose from intake manifold. Refer to . 2. Disconnect A/C piping from A/C compressor, and temporarily fasten it on vehicle with a rope. Refer to 3. Disconnect brake booster vacuum hose. Vehicle inside Disconnect intermediate shaft at steering gear assembly side. Refer to . Vehicle Underbody 1. Remove front wheel sensor (LH and RH) for ABS from steering knuckle. Refer to 2. Remove brake caliper assembly with piping connected from steering knuckle. Temporarily secure it on the |