|
|
содержание .. 677 678 679 680 ..
PS-2 [F9Q] PRECAUTIONS [F9Q] PRECAUTIONS PFP:00001 Precautions for Models with SRS Air Bag and Seat Belt Pre-tensioner EGS000N3 WARNING: ● Before removing and installing components and harnesses of SRS air bag and seat belt pre- ● Do not use pneumatic or electric tools to remove and install the components. ● Do not solder SRS air bag and seat belt pre-tensioner system harnesses when making repairs. ● When checking the SRS air bag and the seat belt pre-tensioner circuit or the components of each ● Never insert foreign material (such as a screwdriver) in the air bag module and seat belt pre- ● Seat belt pre-tensioner and SRS air bag harnesses can be distinguished from other harnesses by ● When servicing, refer to “SB Seat Belt” and “SRS Air Bag” for safety. Caution EGS000N4 ● Always follow the warnings and the cautions below in disassembly procedures: – Work in a clean, dust-free place. No dust proof device is necessary. – Clean outside of unit before disassembly. – Clean parts to be disassembled. Be careful not to allow any dirt or other foreign materials to enter or con- – Assemble disassembled parts properly, following order shown in manual. If work has been suspended in – Use paper towels when removing dirt and other foreign materials. Cloth shop towels can leave lint on – Clean disassembled parts (except rubber parts) with kerosene. Drain oil by blowing with air or absorbing – Before assembling, apply DEXRON TM III or Nissan Power Steering Fluid Special to O-rings and seals. – Replace gaskets and O-rings with new ones. Be careful not to damage any O-rings, oil seals, and gaskets ● Mark source of fluid leak with a white marker for identification. ● Seals and copper washers must not be reused. |