|
|
DAS CHASSIS CONTROL MODULE DAS-225 < ECU DIAGNOSIS INFORMATION > [CHASSIS CONTROL] C D E F G H I J K L M B N P A ECU DIAGNOSIS INFORMATION CHASSIS CONTROL MODULE Reference Value INFOID:0000000010416976 CONSULT DATA MONITOR STANDARD VALUE NOTE: Monitor item Condition Reference values in normal operation IGN VOLT Ignition switch ON 10 − 16 V CONTROL MODULE MALF When chassis control module is normal Off When chassis control module malfunction is On CAN DIAG STATUS When diagnosis of CAN communication mal- Off When diagnosis of CAN communication is nor- On STP LAMP OFF RELAY 1 Displayed but not used. — STP LAMP OFF RELAY 2 Displayed but not used. — ESS RELAY Displayed but not used. — VEHICLE SPEED Vehicle Stopped 0 km/h (0 MPH) Driving * Almost same reading as speedometer ± 10%) FR WHEEL SPEED Vehicle stopped 0 rpm Driving * Increases according to vehicle speed FL WHEEL SPEED Vehicle stopped 0 rpm Driving * Increases according to vehicle speed RR WHEEL SPEED Vehicle stopped 0 rpm Driving * Increases according to vehicle speed RL WHEEL SPEED Vehicle stopped 0 rpm Driving * Increases according to vehicle speed STEERING ANG SENSOR When driving straight 0 ± 3.5 deg When steering wheel is steered to RH by 90 ° Approx. +90 deg When steering wheel is steered to LH by 90 ° Approx. − 90 deg DECEL G SENSOR Vehicle stopped Approx. 0 G When during acceleration Positive value When during deceleration Negative value SIDE G SENSOR Vehicle stopped Approx. 0 G When right turn Negative value When left turn Positive value YAW RATE SENSOR Vehicle stopped Approx. 0 deg/s When right turn Negative value When left turn Positive value ACCELE PEDAL POSITION When accelerator pedal is released 0% When accelerator pedal is depressed 0 − 100% |