|
|
BR-50 < PRECAUTION > [RHD] PRECAUTIONS Precaution for Procedure without Cowl Top Cover INFOID:0000000010305431 When performing the procedure after removing cowl top cover, cover Precaution for Brake System INFOID:0000000010305432 WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with com- CAUTION: • Only use “DOT 4” brake fluid. Refer to MA-59, "Fluids and Lubricants" . • Never reuse drained brake fluid. off immediately and wash with water if it gets on a painted surface. • Always clean with new brake fluid when cleaning the master cylinder, brake caliper and other com- ponents. • Never use mineral oils such as gasoline or light oil to clean. They may damage rubber parts and cause improper operation. • Always loosen the brake tube flare nut with a flare nut wrench. flare nut torque wrench (A). • Always confirm the specified tightening torque when install- ing the brake pipes. • Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) connector or the battery nega- • Check that no brake fluid leakage is present after replacing the parts. • Burnish the brake contact surfaces after refinishing or replac- ing rotors, after replacing pads, or if a soft pedal occurs at BR-79, "BRAKE PAD : Inspection (front brake pad), BR-82, "BRAKE CALIPER ASSEMBLY : Inspection and Adjust- BR-85, "BRAKE PAD : Inspection and Adjustment" (rear brake pad), "BRAKE CALIPER ASSEMBLY : Inspection and Adjustment" (rear disc rotor). PIIB3706J JPFIA0061ZZ |