Ford Crown Victoria (2011 year). Manual - part 50

 

  Index      Ford     Ford Crown Victoria - service manual 2011 year in english

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  48  49  50  51   ..

 

 

Ford Crown Victoria (2011 year). Manual - part 50

 

 

The usage of a full-size dissimilar spare tire/wheel can lead to
impairment of the following:
• Handling, stability and braking performance
• Comfort and noise
• Ground clearance and parking at curbs
• Winter weather driving capability
• Wet weather driving capability
• All-wheel driving capability (if applicable)
• Load leveling adjustment (if applicable)
When driving with the full-size dissimilar spare tire/wheel additional
caution should be given to:
• Towing a trailer
• Driving vehicles equipped with a camper body
• Driving vehicles with a load on the cargo rack
Drive cautiously when using a full-size dissimilar spare tire/wheel and
seek service as soon as possible.

Full-size matching spare tire/wheel information

This spare tire/wheel will match the road tire/wheel. When driving with
the full size matching spare tire/wheel, do not exceed 70 mph
(113 km/h). It is intended for temporary use only. This means if you
need to use it, you should replace it as soon as possible.

Stopping and securing the vehicle

1. Park on a level surface, set the
parking brake and activate hazard
flashers.

2. Place gearshift lever in P (Park)
and turn engine off.

HOOD

Roadside Emergencies

203

2011 Crown Victoria (cro)
Owners Guide, 3rd Printing
USA 
(fus)

Removing the spare tire and jack

1. Remove the spare tire and the
jack. The jack could be located:
• A — behind the mini spare tire or
• B — behind the full size spare

tire

WARNING: On vehicles
equipped with air

suspension, turn off the air
suspension switch prior to jacking,
hoisting or towing your vehicle.

Refer to Air suspension system in the Driving chapter.

2. Remove the lug wrench from the
jack. Rotate the lug wrench socket
out from the handle.

OFF

A

Roadside Emergencies

204

2011 Crown Victoria (cro)
Owners Guide, 3rd Printing
USA 
(fus)

Tire change procedure

WARNING: When one of the front wheels is off the ground, the
transmission alone will not prevent the vehicle from moving or

slipping off the jack, even if the vehicle is in P (Park).

WARNING: To help prevent the vehicle from moving when you
change a tire, be sure the parking brake is set, then block (in

both directions) the wheel that is diagonally opposite (other side and
end of the vehicle) to the tire being changed.

WARNING: If the vehicle slips off the jack, you or someone else
could be seriously injured.

WARNING: Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the road to

avoid the danger of being hit when operating the jack or changing the
wheel.

Note: Passengers should not remain in the vehicle when the vehicle is
being jacked.

1. Block the diagonally opposite
wheel.

2. Remove any wheel trim. Insert
the tapered end of the lug nut
wrench behind wheel covers or
hubcaps and twist off.

3. Loosen each wheel metal lug nut
one-half turn counterclockwise but
do not remove them until the wheel
is raised off the ground.

Roadside Emergencies

205

2011 Crown Victoria (cro)
Owners Guide, 3rd Printing
USA 
(fus)

Before placing the jack under the vehicle, NOTE the jack location

markings:

JACK LOCATION

The jack location markings can be
found on the lower outer edge of
the body.
• Locate the jack locator mark (B)

on the body (C) near the tire you
are changing, then place the jack
(D) under the frame (A) of
the vehicle 
aligning it with the
mark (B).

• Position the jack according to the

following guides and turn the jack
handle clockwise until the wheel
is completely off the ground.

WARNING: To lessen risk
of personal injury, do not

put any part of your body under
the vehicle while changing a tire.
Do not start the engine when your
vehicle is on the jack. The jack is
ONLY meant for changing the tire.

• Never use the rear differential

as a jacking point.

4. Remove the metal lug nuts with the lug wrench.

5. Replace the flat tire/wheel assembly with the spare tire/wheel
assembly, making sure the valve stem is facing outward. Reinstall lug
nuts until the wheel is snug against the hub. Do not fully tighten the lug
nuts until the wheel has been lowered.

A

D

B

C

Roadside Emergencies

206

2011 Crown Victoria (cro)
Owners Guide, 3rd Printing
USA 
(fus)

 

 

 

 

 

 

 

Content   ..  48  49  50  51   ..